Direct Answer: Test The Jig With The First And Last Numbers
Check TYVOK P2 wood token numbering jig registration before membership tag runs so each token lands in the same location.
How Numbered Tokens Drift In A Repeat Jig
Small businesses making numbered tokens or tags need repeatable placement; the demand is less about design and more about not drifting across a run.
Blank Stop And Registration Routine
- Place three tokens in the jig: first number, middle number, and last number.
- Check whether the stop edge holds each blank without rotation or side play.
- Photograph the numbered tokens in order before approving the full member run.
Membership Tag Run Checks
| Check | Passing Evidence | Rework Signal |
|---|---|---|
| Stop edge | token touches two fixed references | blank can rotate in the pocket |
| Number position | first and last numbers share the same margin | last number creeps toward edge |
| Swap speed | blank changes do not move the jig | operator nudges the fixture each cycle |
| Run record | approved photo shows three positions | only one token is checked |
TYVOK P2 Product Details For Jigged Token Work
For wood token numbering jigs, TYVOK P2 is used to check repeat-job jig registration before the buyer commits to the next run. Keep the live product page with this job note, then retest whenever the stop edge or setup changes after you place three tokens in the jig: first number, middle number, and last number: https://tyvok.com/products/tyvok-p2-galvo-laser-engraver
Buyer Questions About Numbering Jigs
Why check the last number before the run?
Longer numbers can change visual balance and reveal margin drift that a single digit hides.
Should the jig hold the token tightly?
It should locate the blank without forcing it; a too-tight pocket slows swaps and can chip edges.
What if token thickness varies?
Sort the blanks and retest the pocket with the thickest and thinnest pieces before numbering.
Run Notes To Keep With The Jig
- Current TYVOK P2 product page
- P2 Supplier-Confirmed Craft Plywood Grain Test Before Logo Sample Pack
- X1S 2026 Long Board Start-Edge Witness Strip Before Large Sign Layout
- X1S 2026 Full-Panel Smoke Map Before Far-Corner Engraving
- X1S 2026 Slot-Together Lampshade Kerf Coupon Before Full Panel Cut
When To Rebuild The Token Stop
The jig is ready when three non-adjacent numbers land in the same visual position without hand correction.
