Short answer: Use this as a starter test path for TYVOK P2 10W, not as a universal preset. Run a small grid on the exact material before customer work.
TYVOK P2 10W starter settings table
| Material | Operation | Starter speed | Power | Passes | Test note |
|---|---|---|---|---|---|
| Basswood gift tag | Engrave | 30-50 mm/s | Medium | 1 | Use same supplier and grain direction for repeat orders. |
| Small wood keepsake | Engrave | 30-45 mm/s | Medium | 1-2 | Clean residue before judging contrast. |
| Coated wood card | Engrave | 35-50 mm/s | Low to medium | 1 | Coating can scorch; start lighter. |
Why 30-50 mm/s is the first band
For P2 10W, this band gives a practical starting point for compact wood gifts without assuming the fastest possible speed will look best.
Wood supplier matters
Plywood glue, grain, moisture, and coating change contrast. Do not reuse one setting across every wood product without a test grid.
When X1S fits better
If the project becomes larger signs, sheets, panels, or batch layouts, move the test to X1S or X1S Pro instead of forcing a compact P2 workflow.
Settings depend on material supplier, coating, thickness, focus, air flow, and software units. Avoid PVC, vinyl, and unknown plastics. For paid work, save the final tested speed, power, passes, photo, and material source.
